BA_PH_436-100_EN_44-21.docx
9
3.4
General Safety Regulations
In general, the following safety regulations and obligations apply when handling the thickness planer:
•
A thickness planer may only be operated in a technically perfect and clean condition.
•
It is prohibited to remove, modify or bypass any protective, safety or monitoring equipment.
•
It is forbidden to modify or alter the machine without the written approval of the manufacturer / supplier.
•
Faults or damage must be reported to the operator immediately, eliminated without delay and repaired if
necessary.
•
For repairs, only original spare parts may be used.
•
All protective, safety and monitoring devices must be regularly checked and maintained by the operator.
•
Only instructed, trained or qualified persons may work on this machine.
•
Maintenance work must be carried out and documented in accordance with the maintenance instruc-
tions.
•
After maintenance or repair, the machine may only be started with all protective devices fitted. A respon-
sible person must be defined for this purpose, who checks that the guards have been properly installed.
For the operation of a thickness planer, the respective national safety regulations for employees as well as the
national safety and accident prevention regulations apply.
