4
3. Remove protective cap from tree middle section 1 (2). Insert tree
middle section 1 (2) into tree bottom section (1). Connect the
connector as shown on page 2.
4. Remove protective cap from tree middle section 2 (3). Insert tree
middle section 2 (3) into tree middle section 1 (2). Connect the
connector as shown on page 2.
ASSEMBLY INSTRUCTIONS
2. Remove protective cap from tree bottom section (1). Insert tree
bottom section (1) into tree stand (5). Fasten the eye bolts
toward the tree trunk. Connect the controller (6) and power
adapter (7) as shown on page 2.
2
1
3
4
5
1
7
3
2
2
1
Eye Bolt
Click
Eye Bolt
1. Set up the tree stand (5) by pulling apart the legs of the stand so
that they are snapped into an x-shape, then place the tree stand
(5) on a level surface.
After inserting the bottom section of the tree into the assembled
stand (5), fasten the eyebolts into the stand and tighten until the
tree pole is firmly secured.
NOTE:
To close the tree stand (5), unfasten the eyebolts, press
the metal button and fold the legs together.
5
