88
2014 Holiday Rambler Travel Trailer
Equipment - 5
Extending - Slideout
1. Press and hold the slideout
room switch in the Out
position. The slideout room
will move slowly to the
out position. Release the
switch any time to stop room
movement. To continue room
movement, press and hold
the switch.
2. Release switch when slideout is fully
extended. The room will lock in
position.
CAUTION:
Continuous operation of the slideout
room can drain the battery and
overheat the motor.
Retracting - Slideout
1. Check for sufficient clearance inside
the recreational vehicle for the
slideout room to retract.
2. Clean the floor to prevent surface
damage.
3. Remove debris from the exterior roof
of the slideout room.
4. Ensure people, pets and objects are
clear of the slide room path.
5. Press and hold switch to In. Release
switch at any time to stop room
movement
6. When the room is fully retracted,
release the switch. The room will
lock into position.
Room Does Not Move When Switch is
Pressed:
Ensure the battery is fully charged.
Check the auto-reset circuit breaker
located underneath the frame behind
the forward cross member. Depending
on model, the breaker is located in a
J-box or inside the “bellypan”.
Manual Override
- Below Floor:
The slideout system is equipped with an
emergency retract feature that allows the
slideout to be retracted in the event of a power
loss.
WARNING:
Do not work on the slideout system
until the battery is disconnected.
Manual Override Procedure:
1. Disconnect the battery cables before
manually overriding the slideout
system.
2. Locate the slideout crank with a
slotted end.
3. Locate the crank access hole on the
outside of the recreational vehicle.
Access will be on the opposite side
from the slideout. A label affixed
to the recreational vehicle reads
“Manual Slideout Crank,” indicating
location.
4. Insert the crank to engage the motor
shaft.
5. Turn the crank to move the slideout
room fully in (or out).
6. Take the recreational
vehicle to an
authorized repair
center.
CAUTION:
Do not continue to
turn the motor after
the room is fully extended/retracted.
Damage to the slide mechanism can
occur.
Direct Drive System:
1. The slideout motor drive mechanism
can be operated with a wrench..
2. Remove 12 Volt DC from the motor
by disconnecting the plug from the
slide-out motor to the power supply.
3. Use a wrench to turn driveshaft and
retract room.
030793b
030833c
090328
Slide-Out
Crank
030750c
Direct drive system
