9
Equipment - 5
2014 Holiday Rambler Travel Trailer
Tips:
A slightly open window on the shaded
side of recreational vehicle will induce
airflow, especially on hot sunny days.
To keep condensation from
accumulating, open the vent lid slightly
to help the air circulate. Condensation
occurs naturally from fluctuations in
interior and exterior temperatures,
humidity and dew point changes, steam
from cooking, or boiling large amounts
of water on the cooktop. Shower usage
also produces condensation.
If the vent fan fails to operate, check
for a blown fuse in the fuse panel.
To clean the screen, remove the screws
holding it in place. Wash the screen
using a non-abrasive soap and water.
Re-install the screen and tighten the
screws.
Sofa
Sleeper Sofa Conversion
The sofa will convert easily into a bed.
Before converting the sofa to a bed clear the
area of obstruction.
Sofa to Sleeper:
Raise the sofa seat base until seat base
and backrest form a V shape by lifting
up from the center of sofa just below
the seat cushions.
Push down on seat base until the seat
base and backrest are flat.
Sleeper to Sofa:
Lift the seat base up until seat and back
rest are in a V shape.
Push down on seat base.
Hide-A-Bed Conversion
The hide-a-bed will
convert easily into a bed.
Clear the area of any
obstructions.
Sofa to Sleeper:
Remove the seat
cushions to access the
hide-a-bed. The seat
cushions should be
stored safely until the
bed is converted back
to a sofa.
Grasp the front metal bar and lift up,
pulling out on the bar slightly until the
leg of the bed is firmly resting on the
floor.
When the legs of the
bed are firmly on the
floor there will be
another lifting bar
exposed to complete
the conversion
process.
Grasp and open the
lifting bar to fully
open the bed.
Sleeper to Sofa:
Remove all bedding.
Grasp the foot of
the hide-a-bed in the
center using the metal
lifting bar.
Fold over the bottom
portion of the bed that
will form the seat.
Lift the front portion of the lifting bar
to raise and lower the hide-a-bed back
into the sofa base.
Replace the seat cushions.
Dinette
Dinette Booth Conversion
The booth dinette converts quickly into a
bed.
Booth to Sleeper:
1. Remove the tabletop from the leg
supports and set aside.
2. Remove the leg supports from the
base and store.
3. Slide the tabletop between the booth
benches allowing it to rest on the
guide rail. Insert safety catches into
latches on seat base before use.
4. Lay both seat cushions and back
cushions together to form a mattress.
020222e
Sleeper Sofa
020222k
Hide-A-Bed
020184
Safety Latches
020184c
For stability, insert safety latches into catches
located in seat base before use
