HLP-NV Series
HLP-NV Series
-
66
-
specified voltage range.
[25] Reverse
Motor runs/is ready to run clockwise
when logic = 0 and counter clockwise
when logic = 1. Output changes as soon
as reversing signal is applied.
[26] Bus OK
Active communication (no time-out)
via serial communication port.
[28] Brake, No Warn
Brake is active, and no warnings are
present.
[29] Brake Ready/No Fault
Brake is ready for operation, and no
faults are present.
[30] Brake Fault (IGBT)
Protects frequency converter if fault
on brake modules is present. Use relay
to cut out main voltage from frequency
converter.
[32] Mech. Brake Control
Enables control of external mechanical
brake, see parameter group C02.2*.
[36] Control Word Bit 11
Bit 11 in control word controls relay.
[51] Local Ref Active
[52] Remote Ref Active
[53] No Alarm
[54] Start Cmd Active
[55] Running Reverse
5-5* Pulse Input
Set par. C05.15 to choice [32] pulse input. Now Terminal EMS handles
a pulse input in the range from Low frequency, par. C05.55, to High
frequency, par. C05.56. Scale frequency input via par. C05.57 and par.
C05.58.
●
Function:
Enter low frequency corresponding to low motor shaft
speed (i.e. low reference value) in par. C05.57.
C05.55 Terminal EMS Low Frequency Default setting
20
Range
[20 - 4999 Hz]
●
Function:
Enter high frequency corresponding to high motor shaft
speed (i.e. high reference value) in par. C05.58.
C05.56 Terminal EMS High Frequency Default setting
5000
Range
[21 - 5000 Hz]
