HL-190 D25 4WD/P/N / HL-220 D25 4WD/P/N
B-165DL25 4WD/P/N / B-195DL25 4WD/P/N
Rev. A
5/2/18
Page 33
6.4
Sliding door safety device (optional)
If the scissor lift has a sliding door, then there is also a proximity switch that detects whether the
door is open. If the proximity switch detects that the door is open, the scissor lift can no longer be
operated. It will also not be possible to lower the platform.
The control box can be operated again when the door has been closed.
When working on the platform, always make sure the door is locked.
6.5
Platform during transport
If the platform railings are folded down during transport, then it is necessary to make sure they are
fitted correctly before the scissor lift is used again.
If the scissor skirt is removed for transport, then the plug for the sliding door must be disconnected.
Do not forget the extra locks for the scissor skirt.
6.6
Oscillating axle
The scissor lift has an oscillating axle. This makes it possible to drive on an uneven floor with four
driven wheels.
The moment that the oscillating axle is not level and the platform is at a height of more than
4 metres, all the driving and lifting functions will be automatically disabled. The fault indication light
on the control box will also flash. To return the oscillating axle to the horizontal position, the scissor
lift must be moved to a flatter surface and the platform must be at a height of less than 4 metres.
Note!
Never use the scissor lift if all the locks have not been secured.
The scissor skirt may never be removed when using the scissor lift.
The platform must be fully retracted during transport.
1.
Oscillating cylinder
2.
Rocking part of the
oscillating axle
3.
Fixed part of the oscillating
axle
Oscillating axle
