AAA 1.5V
AAA 1.5V
12
CHARGING WAY
●For Safety purpose ,the charging must be done by adults.
●The first time you use it, please open the bonnet, connect two clip locks of red
wires, use it only after charging 8-12 hours.
●Charging socket is locate on the dashboard, please follow the instructions to
charge the battery.
●If the car has slowed down, it needs to be charged by 8-12 hours, maximum 20
hours.
1.First insert the plug of the charger into the charging port. (The car can not be
used.)
2.Then insert the charger to the power socket.
WARNING:
1 . When operating the car, the distance between the car which kid sit in and
the remote control which operated by adults should not be more than 10
meters.
2 .The remote is only for adults to use, keep far away from child.
3 .Before using the remote, you must read the instruction manual carefully, and
operate the empty car first , only when knowing the way of operation, you can
use the remote with kid in the car.
4.Please switch to the "P"of the gear before you get on the car.
5.This product should not be used on traffic road and the place with water and
obstacles.
6 . To Avoid damaging the circuit, please keep the remote control from wet and
in rains.
7 .Don’t mix old and new batteries and different brands of dry batteries.
8 . In order to avoid damaging the remote control, please take out the batteries
if not use the remote control for a long time to avoid battery leakage and circuit
corrosion.
9.Avoid dropping the remote control during using.
10.Install batteries with right polarity to avoid battery short circuit.
11.Charging must be done by adults. Non rechargeable batteries can't be
charged.
12.Exhausted battery should be removed from the toy properly and prevent
children from playing.
13.Take out the battery if no use for long time, properly handle the battery, and
prevent children from playing.
14.If the remote distance is less than 3 meters, it means the battery is down in
the remote control, it is time to change the 2 pieces of AA alkaline batteries.
How to insert batteries: Use screwdriver to loosen
the screw on the back of the remote control, open
the battery cover, and install two AAA 1.5V
alkaline type batteries according to the diagram
(Batteries are self-provided), then close the
battery cover,and fix with screw.
