Page 1
OPERATOR'S MANUAL
HOLMAN CONVEYOR TOASTERS
MODELS T710(H, TW, TX) T714(H, TW, TX) S710(H) S714(H) B710H
UNCRATING AND INSPECTION
Unpack unit and components from container. Remove all visible packing
material, inspect unit for damage. If damage is discovered, file a claim
immediately with the carrier that handled the shipment.
ASSEMBLY AND INSTALLATION
A. Attach legs by screwing into weld nuts, as shown below.
AT EACH CORNER ON BOTTOM SIDE OF TOASTER
LEVELING OF THE TOASTER CAN BE DONE BY TURNING
THE FOOT SECTION OF THE LEG COUNTER CLOCKWISE
ADJUSTABLE LEG: SCREWS INTO WELD NUT LOCATED
B. Anti Skid pads are available at no charge and may be adhered to the foot
section of each leg to prevent sliding. Call 1-800-225-3958 for details.
WARNING:
the National Sanitation Foundation does not approve Use of
these pads.
C. Place load and unload trays as shown below.
LOAD UP TRAY
HEAT REFLECTOR / CRUMB TRAY
TOAST CHUTE
TOAST CHUTE
(REAR DISCHARGE)
CAUTION: DO NOT OPERATE UNIT WITHOUT
CRUMB TRAY PROPERLY POSITIONED
AS THIS WILL CAUSE OVERHEATING IN THE
CONTROL BOX.
WARNING:
MAKE SURE ALL INPUT POWER IS
OFF
BEFORE INSTALLING/REMOVING
ANY PARTS.
WARNING:
BEFORE INSTALLING UNIT(S), CHECK WITH LOCAL POWER COMPANY TO
DETERMINE ACTUAL VOLTAGE AT JOB SITE. NEVER PLUG A 208-VOLT UNIT
INTO 240 VOLTS OR A 240 VOLT UNIT INTO 208 VOLTS.
WARNING:
BE ABSOLUTELY SURE THE GROUND CONNECTION FOR THE RECEPTACLE
IS PROPERLY WIRED. NEVER CONNECT UNIT TO POWER WITHOUT
PROPER GROUND CONNECTIONS. IMPROPER GROUND MAY RESULT IN
SEVERE INJURY OR FATALITY.
REVISED
9/10/2008
