CLEANING continued
WEEKLY
1. Turn main Power switch to the
OFF
position. Disconnect unit from power source and
allow to cool.
2
.
Perform daily cleaning procedures.
3. Using a damp cloth, wipe clean the fan guard located on the control box cover
under the unit.
IL1153
CONVEYOR BELT CLEANING
PROCEDURES
4. Reconnect power or turn power back on.
5. Switch the ON/OFF switch to the ON
position, and turn conveyor to its fastest
setting.
6. With the conveyor turned on and the crumb
trays in place, take a wire grill brush or dry
abrasive pad, clean the exposed surface
of conveyor belt by passing the brush or
pad, back and forth across the surface
of the conveyor belt as the belt moves
past. continue until the entire belt is clean.
Make sure the crumb tray is installed; this
will minimize the amount of particles that
fall into the toaster.
7. When the Conveyor Belt is clean, take a damp cloth and wipe the conveyor, removing any
loose particles on the belt surface. Turn Conveyor OFF.
8. Remove the Crumb Trays by sliding out from beneath the conveyor belt and discard soiled
aluminum foil. If cleaning is necessary, use a damp cloth and mild detergent.
DO NOT
use caustic cleaners.
DO NOT RUN CONVEYOR OVEN WITHOUT CRUMB TRAYS INSTALLED.
9. Cover crumb trays with clean aluminum foil and put back to its correct position.
DO NOT IMMERSE OR LET THE UNIT STAND IN WATER.
DO NOT HOSE DOWN THE UNIT OR THE TABLE/COUNTER IF THE UNIT IS ON
THE TABLE/COUNTER.
KEEP AWAY FROM RUNNING WATER.
WARNING
