4
GENERAL INSTALLATION DATA
This equipment is designed and sold for commercial use only by personnel trained and
experienced in its operation and is not sold for consumer use in and around the home nor
for use directly by the general public in food service locations.
Before using your new equipment, read and understand all the instructions & labels
associated with the unit prior to putting it into operation. Make sure all people associated
with its use understand the units operation & safety before they use the unit.
INSPECTION & ASSEMBLY
All shipping containers should be checked for freight damage both visible and concealed.
This unit has been tested and carefully packaged to insure delivery of your unit in perfect
condition. If equipment is received in damaged condition, either apparent or concealed, a
claim must be made with the delivering carrier.
Concealed damage or loss - if damage or loss is not apparent until after equipment is
unpacked, a request for inspection of concealed damage must be made with carrier within
15 days. Be certain to retain all contents plus external and internal packaging materials for
inspection. The carrier will make an inspection and will supply necessary claim forms.
UN CRATING AND INSPECTING
Unpack the unit and components from the shipping container. Remove all visible packing
material. If damage is discovered, fi le a claim immediately with the carrier that handled the
shipment.
DO NOT
operate the unit if it was damaged during shipping.
The following should be included: Holman Conveyor Sandwich Toaster, Stainless Steel Unload Tray,
(four) 4 Stainless Steel Legs, 2 crumb trays, extra Motor, and Magnetic Bake Aid w/Bracket.
ASSEMBLY AND INSTALLATION
The unit was shipped with certain assembly required.
LEG INSTALLATION
IL1337
To attach the four 4 legs, with assistance place the unit on
its end as shown (damage to the controls can occur when
the unit is placed on the control side) insert the legs by
screwing them into the weld nuts located on the bottom
of the unit. When completed and with help, carefully turn
the unit upright.
NEVER OPERATE UNIT WITHOUT PROPER LEGS IN
PLACE.
Install unit in its operating position. Level unit by adjusting
the feet. Both ends must be at least 6" from any vertical
combustible surface. Allow suffi cient space for operating
personnel.
The Unload Tray has a keyhole slot on the tray that
will slide over the two screw heads on the end of
the toaster as shown in the Toaster Components
Illustration.
The crumb tray slides into each end of the toaster
under the conveyor. They keep the interior of the
machine clean and refl ect heat away from the controls and back up to the sandwiches. A
layer of aluminum foil on the tray (check that it does not interfere with the conveyor) will
make the tray more refl ective and make cleanup easier.
CAUTION
CAUTION
