EN
JJ/PL
917.219.005_005
25
•
Prop the load immediately.
•
Stop lifting on the instant the red stroke end mark (Fig. 4/5) appears on the plunger.
•
Remove the lever if the load has to remain in its position for an extended period.
6.2.3
Lower the load
•
Set the control slide in the “DOWN” position (Fig. 6).
•
Let the load lower by moving the lever up and down.
6.2.4
Use more than one jack
•
Distribute the weight equally over the two jacks when more than one jack is used.
•
Select a jack with adequate capacity. A jack is normally loaded to only 50 to 70% of its capacity.
•
Lift uniformly and in a controlled manner when using more than one jack. This can be achieved with
directions from a supervising or other person to ensure that the jack remains in balance and the
load remains centred.
6.2.5
Use a longer lever
•
Use a longer lever at a load > 60% of the allowable capacity of the jack.
•
Operate the lever with two persons if the operating force exceeds 400 N.
6.2.6
Pull the load with PL 2510
•
Set the control slide in the “UP” position.
•
Move the lever up and down to extend the plunger.
•
Attach the pulling eyes.
•
Set the control slide in the “DOWN” position.
•
Move the lever up and down to withdraw the plunger and to move the loads towards each other.
6.3
After use
6.3.1
Shut down
•
Retract the plunger.
•
Ensure that the saddle is loose from the housing at all times.
6.3.2
Inspection
•
Check the tool for completeness, leaks and damage. Do not use the tool if it leaks or is damaged
and contact the Holmatro dealer.
6.3.3
Cleaning and storage
•
Clean the tool and any accessories before storage.
•
Dry the tool if it has been used in wet conditions. Lightly oil the steel parts.
WARNING
Ensure that the load is propped or that measures are taken to prevent sudden lowering of the
load resulting in any hazards. The self-locking nature of the jack may not be adequate in all
situations.
Summary of Contents for 200.401.001
