EN
PCU50
916.400.096_003
45
•
Start the tool with the on/off switch.
6.3.2
Tool movement
The cutting blades close relatively quickly until they encounter resistance. Then the pump will build up
the required pressure for the cutting action.
6.3.3
Cutting
1. Open the blades.
2. Place the tool with opened blades perpendicular to the object to be cut.
3. Place the object to be cut as deeply as possible in the cutting opening.
4. Close the blades.
6.3.4
Maximum force indicator
Refer to 3.4, 2.
When the maxmimum pressure is reached, the tool stops automatically to save energy. The maximum
force indicator comes on.
•
Release the deadman’s handle to bring it back to neutral position.
•
The tool can be operated again.
NOTICE
It is highly recommended to have at least one fully charged spare battery pack available at
all times.
NOTICE
To protect the battery pack, the tool will stop as soon as the battery pack becomes empty.
The tool can be fixated at that moment. To remove the tool it is best to replace the battery
pack by a fully charged battery pack.
WARNING
Take extreme care during tool movement. Because of the enormous power of the tool parts
of the body can easily be crushed or pinched.
NOTE
When the tool is put in water it is possible that it operates in safe mode:
•
The motor operates at slow speed.
•
The motor will not stop when you release the control handle or put into neutral position.
It is allowed to continue.
CAUTION
Do not cut hardened fastenings, bolts, etc. because this can damage the blades.
WARNING
Stop immediately if the blades are out of line. Danger of serious injury and of serious damage
to the equipment.
Summary of Contents for PCU50
Page 3: ...PCU50 916 400 096_003 3 Fig 1 Fig 2 ...
Page 4: ...4 916 400 096_003 PCU50 Fig 3 Fig 4 Fig 5 ...
Page 173: ...PCU50 916 400 096_003 173 i Fig 6 Fig 7 ...
Page 174: ...174 916 400 096_003 PCU50 Fig 8 Fig 9 Fig 10 Fig 11 90 C A A B ...
