Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH.
Final assembly by Holtkötter International, Inc. in South St. Paul, MN.
Holtkötter
®
and Holtkötter Leuchten
®
are registered trademarks
of Holtkötter International, Inc. All Rights Reserved.
© Holtkötter International, Inc.
HOLTKÖTTER
INTERNATIONAL, INC.
www.holtkoetter.com
e-mail: customerservice@holtkoetter.com
ASSEMBLY INSTRUCTIONS FOR
(B) Finished Reflector Cover
(E) Aluminum Nuts
(A) Glass Shade
(D) White Shade Support
(F) Bulbs
(J) Glass Shield Holder
(L) Washers
(H) Finished Screws
(C) Small White Knobs
(G) Frosted Glass Shields
(K) Allen Wrench
Assembly Instructions (see diagram):
To install the glass shade (A), remove the finished reflector cover (B) by
1.
unscrewing the small white knobs (C) located just below the white shade
support (D). Set the cover and knobs aside.
Next remove the aluminum nuts (E) from the column. Install the glass shade
2.
over the white shade support (D) and screw the aluminum nuts (E) back in
place.
Now reinstall the finished reflector cover (B) by placing it over the installed
3.
glass shade (A). Align the cover with the glass and screw the small white
knobs (C) back in place.
To install the bulbs (F), insert the bulb into the bayonet socket. The bulb
4.
is inserted by pushing it slightly down into the socket and then turning it
clockwise. Repeat on the other side.
NOTE: BE CAREFUL NOT TO TOUCH THE
BULB WITH YOUR BARE HANDS.
Next, remove the finished screws (H) and washers (L) located below the
5.
glass shield holder (J) with the allen wrench (K). Set aside.
Finally, install the frosted glass shields (G). Holding the glass shield in place
6.
with the smooth side down, carefully align the shield with the holder, place
the washer (L) on the screw (H) and tighten in place. DO NOT OVERTIGHTEN.
Repeat on the other side.
Plug the lamp into the outlet. Your lamp is now operational.
7.
Assembly Diagram
Halogen Table Lamp
No. 6247/2
