e-mail: customerservice@holtkoetter.com
www.holtkoetter.com
ASSEMBLY INSTRUCTIONS FOR
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.
Holtkötter
®
and Holtkötter Leuchten
®
are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
Halogen Table Lamp
No. 6552*P1
Please make sure the following parts are included:
1. Lamp Base
(A)
with Punkt1 (*P1) dimmer
(D)
2. Bulb
(B)
: 60 Watt Halopin, Frosted (Order Code: 9250*060-HPNFR)
3. Glass Shade
(C)
Install the Bulb and Glass Shade
1. Install the new bulb, being careful not to touch the bulb envelope with your bare
hands. Insert it into the socket and push it down.
2. Once the bulb is installed, place the threaded end of the glass over the bulb and
onto the socket.
3. Screw the glass shade down on the fixture until it is firmly in place.
4. Your lamp is now operational.
Note of Caution
The recommended replacement bulb for this fixture is the 60 Watt Halopin bulb (frosted).
Replace the Fuse
An integrated fuse to protect the dimming circuit can be found in the box housing the plug.
Please check the fuse first, in case the lamp does not come on. A four (4) Amp replacement fuse
can be found on the Holtkoetter parts website:
http://www.holtkoetter.com/products/parts/
fuse-4amp.aspx
or at your local automotive or electronics parts store.
1. Unscrew the screws (G) located on each corner of the plug housing (E).
2. Open the housing to reveal the circuit board.
3. Locate the black box inside labeled
Fuse 5 x 20
(F)
and open it.
4. Remove and discard old fuse;
replace with the new fuse.
5. Close the small fuse box and the plug
housing.
6. Replace and tighten the four screws
on the outside of the plug housing.
B
C
D
A
F
G
E
