Holtkoetter Bernie Series, Assembly Instructions

Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH.
Final assembly by Holtkötter International, Inc. in South St. Paul, MN.

Holtkötter 

®

 and Holtkötter Leuchten

®

 are registered trademarks

of Holtkötter International, Inc.  All Rights Reserved.

© Holtkötter International, Inc.

HOLTKÖTTER INTERNATIONAL, INC.

155 Hardman Avenue South, South St. Paul, MN  55075

fax:  (888) 552-8661 • phone:  (800) 899-5444

ASSEMBLY INSTRUCTIONS FOR

www.holtkoetter.com

e-mail:  customerservice@holtkoetter.com

Bernie Series Floor Lamps

No. 6440/1 & No. 6442/2

These low-voltage halogen floor lamps come fully assembled.

Glass Shield and Bulb Replacement Instructions

1.  Be sure to turn the lamp off and allow it to cool before attempting glass shield and/or 

bulb replacement.  

2.  The glass shield (A) is held in place with a spring clip (B).  To remove this clip, hold 

each side and pull firmly from the socket.  This will release the glass shield. (Skip to 
Step 5 unless replacing bulb).

3.  To remove the old bulb (C), pull it straight out of the socket.  For a replacement bulb, 

use only Osram Halostar IRC, max. 50 W.  (Order Code:  9250*050-HSTAR.)

4.  Install the new bulb, being careful not to touch the bulb envelope 

with your bare hands.  Hold the bulb at the porcelain grip and push it 

straight into the socket.  

5.  Press the aluminum clip over the shield and onto the socket, making sure that both 

sides snap into place.

UL requires the following safety instructions:

Lighted lamp is HOT!  WARNING:  Improper use of this fixture may increase the risk of FIRE, 
ELECTRICAL SHOCK, EXPOSURE TO EXCESSIVE RADIATION or INJURY TO PERSONS.  

IN ORDER TO REDUCE THESE RISKS, PLEASE FOLLOW THESE SAFETY INSTRUCTIONS: 
1.  Before replacing bulb, UNPLUG lamp and allow bulb to cool. 
2.  DO NOT touch hot glass shield or operate lamp with a missing glass shield.
3.  Keep lamp away from materials that may burn.
4.  Do not remain in light if skin feels warm or look directly at a lighted bulb. 
5.  Use of the Osram bulb provided with this lamp prevents exposure to excessive 

UV Radiation.  Use of any other bulb may cause a risk of exposure to excessive 
UV Radiation.  Use of any other bulb may also cause a risk of overheating or may 
rupture the bulb.

Care Instructions

Use only a soft, dry cloth to clean.  If necessary, a slightly damp, soft cloth can be used to 
spot clean.  Do not use common household cleaners on lamps or fixtures, as the lacquer 
on the outside of the brass may be damaged as a result.

(B)

(A)

(C)

Diagram