Important Tips:
1. The model is equipped with powerful and responsive motors. If you are beginner, please fly
the drone on a soft ground, like a lawn or above a carpet. Throttle up slowly and fly with low
speed to avoid damage from losing control.
2. The motors and circuit board will heat up with use. Take a 10 minutes cool down break
between flights to ensure your parts last as long as possible.
3. Pay attention to the wires which are connected to the circuit board and protect them from
being pulled loose or even disconnected from the circuit board (especially when one is
disconnecting the battery).
Note: Always pay close attention to battery polarity when inserting any batteries to make sure
they are fitted correctly.
1. Open the battery cover on the back of the transmitter, install 4 AA batteries according to
electrode instruction. Do Not mix new and old batteries, and Do NOT use different types of
batteries.(Batteries are not included in the box)
Take Photo:
Press this button to take photos. The camera will take a photo every time you
press this button.
Throttle Stick:
Push up on the joystick to increase throttle and ascend. Push down on the
joystick to decrease throttle or descend.
Speed Mode:
Low/Med/High/Expert
Engine Start/ Stop:
Press this button to start the motors and get ready for take off. When
flying, press this button to land.
Setting Up the Transmitter
-5-
(Not included)
