-09-
•Return to Home (RTH)
Press the button to start the RTH, the transmitter makes a beep sound
and the drone will fly back to the recorded Home Point.
Press the RTH button again to exit RTH procedure and regain control of
the drone.
•Photo/Video
•Speed Switch
Long press the button “ ” in the upper right corner, the LCD screen
showing “ ”, and you will hear a beep, which means the drone is at the
low speed.
Long press the button “ ” again, the LCD screen showing “ ”, and you
will hear two beeps, which means the drone is at the high speed.
•GPS Mode Switch
•Emergency Stop
Short press the button and the camera icon “ ” on the LCD screen
flashes once, and the camera takes one photo.
Long press the same button, the video icon “ ” on the LCD screen
flashes slowly,
and the camera is
taking video. Long press the button
again the camera will stop video recording.
After turning on the transmitter, the GPS Mode is default on. GPS mode can
be turn off by sliding GPS switch. Check the icon “ ” or “ ”on the LCD
screen to confirms GPS status.
Press and hold the button ” “ for 3 seconds, the motor will stop immedi-
ately. Be aware that you risk breakage of the drone if it falls a large distance
or hits anything at a high rate of speed.
Attention:
The Emergency Stop function should only be use during
emergency to avoid any damage or injury.
