7
Preparation for flight
●Double check the place where the pilot uses the model, make sure that
it is free from the crowd, animals and other barrier.
●Turn on the remote controller and the
power indicator light flashes rapidly and
sends out connectional signal to the drone.
●Slide the throttle control stick up to the top;
then, return the throttle control stick down
to the bottom; It will take about 10 seconds
to finish the signal connection process.
Once signal connection is completed,
the power light will stay "on" without
blinking and the remote controller is
ready for flight.
The remote control
NOTE:Battery should be fully charged before storing.
Turn off the switch, plug the battery to
the power wire which is connected to
the jack-plug. The charging plug of
USB charger is connected to the
three-wire plug on the battery.
During the charging, USB charger
indicator light is on. When the
battery is fully charged, the LED
light of the USB charger turns off.
The charing time lasts about 40 minute.
The method of the Li-Po battery charging
Battery
Charger
(5V 0.5-1A)
Not included
Three wire plug
Plug the power
cord connection
USB