[Type here]
[Type here]
P a g e
|
20
KOPIS 1
6.
In the Endpoints screen, Ok scrolls between channels. Up/Down adjusts the endpoint. You
control whether you are adjusting the top or bottom endpoint by raising or lowering the stick
for the channel you are adjusting. This can be a little confusing because it’s probably not obvious
to most people which channel goes with which stick. The default channel order for the FlySky
radio and for Betaflight is:
•
Channel 1 = Aileron = Roll = Right stick left/right axis
•
Channel 2 = Elevator = Pitch = Right stick up/down axis
•
Channel 3 = Throttle = Left stick up/down axis
•
Channel 4 = Rudder = Yaw = Left stick left/right axis
7.
For each of channels 1, 2, 3, and 4, adjust the top and bottom endpoint. Do this by holding the
correct stick full left or down to adjust the bottom endpoint and full right or up to adjust the top
endpoint. Then use the up/down buttons on the FlySky FS-i6 to adjust the endpoint % until the
Betaflight Configurator Receiver Tab shows 1000 (for the bottom endpoint) or 2000 (for the top
endpoint).
