18
CUTTING OPERATION
Always Cut by Guiding the head from your right to le .
Adjust the idle speed (see page X) for di
ff
erent types of grass you cut e.g cut tough shrubs or weeds at a high idle, and young
grass at a middle speed.
A metal blade cut best up to the point 1/3 from the edge. Use that area for cu ng shrubs, tough and thick weeds. For cu ng
young grass, you can use up to 2/3 from the p of the blade.
MAINTENANCE OF MACHINE
GEAR CASE
Please Supply Mul -purpose grease at every 25 hours of use. Remove the cu er holders to arrange for old grease to exsist.
MAITENANCE BEFORE STORAGE
Brushing o
ff
dirt from the machine, check damage or slack of each part. If you
fi
nd out abnormali es,
repair them for the next use.
Extract fuel from the tank, and loose the drain screw of the
fl
oat cabin to extract fuel, turn on the engine, and leave it running
un l it stops naturally.
Remove the spark plug and put in 1-2cc of 2 cycle oil in the engine. Draw the starter 2-3 mes, set the plug back and stop it at
the
contac on posi on.
Apply an -rust oil to the metal parts such as the thro le wire, put the cover on the blade, and keep it indoor avoiding dampness.
PLEASE BE AWARE THAT THE CUTTING ATTACHMENTS CAN CONTINUE ROTATING AFTER THE ENGINE IS
SWITCHED OFF! SO PLEASE WATCH OUT FOR THIS. WE RECOMMEND USING 20:1 UNLEADED FUEL TO OIL
MIXTURE FOR THIS BRUSHCUTTER.
18
CUTTING OPERATION
Always Cut by Guiding the head from your right to le .
Adjust the idle speed (see page X) for di
ff
erent types of grass you cut e.g cut tough shrubs or weeds at a high idle, and young
grass at a middle speed.
A metal blade cut best up to the point 1/3 from the edge. Use that area for cu ng shrubs, tough and thick weeds. For cu ng
young grass, you can use up to 2/3 from the p of the blade.
MAINTENANCE OF MACHINE
GEAR CASE
Please Supply Mul -purpose grease at every 25 hours of use. Remove the cu er holders to arrange for old grease to exsist.
MAITENANCE BEFORE STORAGE
Brushing o
ff
dirt from the machine, check damage or slack of each part. If you
fi
nd out abnormali es,
repair them for the next use.
Extract fuel from the tank, and loose the drain screw of the
fl
oat cabin to extract fuel, turn on the engine, and leave it running
un l it stops naturally.
Remove the spark plug and put in 1-2cc of 2 cycle oil in the engine. Draw the starter 2-3 mes, set the plug back and stop it at
the contac on posi on.
Apply an -rust oil to the metal parts such as the thro le wire, put the cover on the blade, and keep it indoor avoiding dampness.
PLEASE BE AWARE THAT THE CUTTING ATTACHMENTS CAN CONTINUE ROTATING AFTER THE ENGINE IS
SWITCHED OFF! SO PLEASE WATCH OUT FOR THIS. WE RECOMMEND USING 20:1 UNLEADED FUEL TO OIL
MIXTURE FOR THIS BRUSHCUTTER.
Summary of Contents for G3MT
Page 1: ......
