SAFETY
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
14
RWH 150XLIFT
12
SAFETY
12.1
Intended Use
The machine must only be used for its intended purpose! Any other use is deemed to be a case of
misuse.
To use the machine properly you must also observe and follow all safety regulations, the assembly
instructions, operating and maintenance instructions lay down in this manual.
All people who use and service the machine have to be acquainted with this manual and must be
informed about the machine's potential hazards.
It is also imperative to observe the accident prevention regulations in force in your area.
The same applies for the general rules of occupational health and safety.
The machine is used for:
To lift up and move vehicles
Any manipulation of the machine or its parts is a misuse, in this case
HOLZMANN-
MASCHINEN
and its sales partners cannot be made liable for ANY direct or indirect
damage.
12.2
Prohibited use
The operation of the machine outside the stated technical limits described in this manual is
forbidden.
The operation of the machine without provided protective devices is prohibited
The use of the machine not according with the required dimensions is forbidden.
Any manipulation of the machine and parts is forbidden.
The use of the machine for any purposes other than described in this user-manual is
forbidden.
It is not allowed to leave the immediate work area during the work is being performed and
keep it out of reach of children!
Never lift persons or vehicles with persons inside!
The using of extensions or other additives for lifting is forbidden!
12.3
Security instructions
Missing or non-readable security stickers have to be replaced immediately!
The locally applicable laws and regulations may specify the minimum age of the
operator and limit the use of this machine!
To avoid malfunction, machine defects and injuries, read the following security instructions!
Before using the floor jack, prevent the vehicle against inadvertent rolling. Engage
handbrake, wedges etc and switch off the engine.
Check if the jack is in good working condition.
Especially check, if the floor jack is leaking hydraulic oil, for right fitting of the screws,
vents and oil filling.
Never use the floor jack to transport loads or to load a vehicle.
Never lift up the whole vehicle.
Do not lift up peoples.
Do not use the floor jack on inclined surfaces. Use the floor jack only on level and solid
ground. Warning! The floor jack may possibly sink in or trip down, if the jack is used
on hot tar macadam ground.
Place the floor jack that way to avoid handling under the vehicle.
Use personal safety equipment: safety shoes S1, work wear, safety gloves (EN 388,
class 3111) when working with or on the machine.
Summary of Contents for 10505851
Page 26: ......
