TROUBLE SHOOTING
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
27
ABS 3000SE / ABS 5000SE
14.2
Cleaning
After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
NOTICE
The usage of certain solutions containing ingredients damaging metal surfaces as
well as the use of scrubbing agents will damage the machine surface!
Clean the machine surface with a wet cloth soaked in a mild solution
14.3
Disposal
Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local dealer
for a replacement unit, the latter is obliged to exchange your old.
15
TROUBLE SHOOTING
BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble
Possible cause
Solution
Machine does not start
Switch defective
Repair switch
Power supply is off
Repair power supply
Fuse is defective
Change fuse
Electric contactor is defective
Repair or change electric
contactor
Dust emerges from
Leaking or blocked connections
Check connection
Remove blockages
Dust bag or filter bag is defective
or incorrectly installed
Check bag and filter
Change defective bag/filter
Loud noise in the fan wheel
housing
Extracting of a big part
Switch of the machine,
disconnect the machine and
remove the part
Loosen fan wheel
Tighten the fan wheel
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY CONNECTION
TO THE ELECTRICITY GRID.
NOTICE
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the
problem.
Summary of Contents for ABS 3000SE
Page 57: ......