OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Seite 45
METALLDREHMASCHINE / METAL TURNING LATHE ED 1000N / ED 1000NDIG
14.4.3
Threading
The pitches are set using the appropriate table for metric and inch thread.
The lock nut is engaged to the lead screw
with the shift lever (
21
) and the thread feed
is in operation.
NOTE:
The lock nut should remain locked during thread cutting.
14.4.4
Tread cycle
The Thread dial located on the right side of the lock case and is used for threading.
With the lock nut of the threading can use the shift lever (
21
) be brought back to the exact
position to intersect with the thread turning tool exactly at the start point on.
NOTE:
In order to keep the wear minimal, the threading should be set back after use.
change gears
- Number of teeth
-
selector switch setting
selector switch
21
thread cycle
selector switch setting
Summary of Contents for ED 1000GDIG
Page 89: ......
