HOLZMANN MASCHINEN Austria www.holzmann-maschinen.at
Page 37
SOUSTRUH NA KOV ED1000KDIG / METAL TURNING LATHE ED 1000KDIG
Apply a thin coat of oil on the machine bed and all other exposed parts like on the tailstock, screw
cutting, etc. once a day.
12.6
Retraction prior to initial
The retraction should be performed with the lowest screw speed. Let the machine at this speed
for about 1 hours walk. Check out irregularities, such as unusual noises, imbalances, etc. If eve-
rything is ok, you gradually increase the speed. The highest speeds may be driven only after 10
hours of operation.
12.7
Leveling tailstock to headstock
Tighten properly between spindle and tailstock up a 305mm long solid piece of pipe.
Cock now in the tool holder has a digital Display one.
Run with manual feed (handwheel) the top slides along the workpiece. When measuring differ-
ences of tailstock is adjusted using the adjustment screw on headstock with tailstock (see figure)
until no more measuring differences exist.
Summary of Contents for ED 1000KDIG
Page 70: ......
