OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
55
ED400FD | ED400FDDIG
Thread Pitch
1,5 mm
The gear spindle gear with 40 teeth thumbs up in gear A
Gear A engages in gear C
Gear D meshes with gear F
"H" stands for white space (sleeve). Instead of a sleeve can also smaller
gear are used, that is with no other gear is engaged.
A B 66
H
C D 40 60
E F
H 80
19.4.14
Lathe Chuck / Face Plate Assembly
If you want to mount or dismount the lathe chuck or a face plate,
first make sure that the retaining cams are fixed.
Loosen the three screws (A) and remove the lathe chuck.
Now mount the chuck or face plate on the spindle head and
tighten the screws one after the other.
Do not exchange chucks or face plates between different lathes
without checking the correct holding cams.
19.4.15
Top Slide
For angular adjustment of the upper slide, loosen the screws,
turn the carriage to the desired position and fix the carriage
again with the screws.
19.4.16
Tailstock
The tailstock serves as a counter bearing when turning between the
centres as well as for holding drilling, countersinking and reaming tools. It
is guided on the cheeks of the lathe bed and can be clamped at any point
by a clamping lever.
The tailstock is secured in the lathe bed (cast bed) with an end position
stop screw to prevent the tailstock from sliding out unintentionally (see
picture on the left).
