ASSEMBLY
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
50
ED1080ADIG
N O T I C E
Avoid using sling chains as there is a risk of damaging the feed screw or the lead
screw. Make sure that the lead screw, feed screw and selector shaft of the lathe are
not touched by the lifting slings when lifting. Never lift the machine by the spindle!
To position the machine at the installation location, proceed as follows:
1.
Place the belt around the machine so that it
cannot slip and that it cannot be damaged.
2.
Lift the metal lathe carefully using a crane
or other suitable lifting device. It is
recommended to use hooks when lifting with
a belt.
Align the belt lengths so that the machine is
horizontal and stable when lifted.
Note: Before lifting, check that the tailstock is clamped. Ensure that the load stop is balanced. If
necessary, change the position of the bed slide and/or tailstock to obtain a balanced load stop.
17
ASSEMBLY
17.1
Preparatory activities
17.1.1
Checking delivery content
Always note visible transport damage on the delivery note and check the machine immediately
after unpacking for transport damage or missing or damaged parts. Report any damage to the
machine or missing parts immediately to your retailer or freight forwarder.
17.1.2
Cleaning and lubrication
Before you install and commission the machine at the intended location, carefully remove the
anti-corrosion protection and grease residues.
Under no circumstances should you use nitro thinner or other cleaning agents that could attack
the machine's paint.
Oil bare machine parts (e.g. machine bed, tailstock sleeve, feed spindle) with an acid-free
lubricating oil.
17.1.3
Site requirements
Place the lathe on a solid surface. A concrete floor is the best foundation for the machine. If
necessary, use an underframe.
The space required by the machine and the required load-bearing capacity of the subfloor result
from the technical data (dimensions, weight) of your machine. When designing the working area
around the machine, observe the local safety regulations. When dimensioning the required space,
take into account that the operation, maintenance and repair of the machine must be possible
without restrictions at all times.
The selected installation location must ensure a suitable connection to the electrical mains.
Summary of Contents for ED1080ADIG
