OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
19
PJ 100A
11.3.2
Selection of timber connectors
Always use the largest possible timber connector for a strong connection. For materials over 25
mm (1 inch) thick, and 2 wood connectors on each usable.
The distance between two should be at least 10 cm.
Wood connectors Dimensions:
Nr. 0
47×15×4mm
Nr. 10
53×19×4mm
Nr. 20
56×23×4mm
11.3.3
Adjustment of the angle stop
The height of the angled guide can be adjusted to adjust the position of the blade relative to the
workpiece upper surface.
To adjust the angle stop height loosen the clamping screw and cause the angle to the desired
tick mark on the crosscut fence.
Then tighten the clamping screw to the angle guide to secure. The scale indicates the distance
between the angle stop and center of the cutting tool.
The angle guide can be removed depending on the job requirements from the stop.
11.3.4
Adjustment of the pivot stop
The flip stop can be set between 0 ° and 90 °.
To adjust the angle loosen the clamping screw and tilt the swivel stop until the arrow indicator
to the desired angle on the angle scale matches.
The adjusted angle with the pinch bolt.
11.4
Operating
11.4.1
Connectivity
1.
corner joint
2.
miter
3.
frame connection
4.
middle wall connection
5.
longitudinal and transverse connecting
NOTE:
Summary of Contents for PJ 100A
Page 43: ......
