HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
29
SHT310 | SHT310PAR
W A R N I N G
The following hazards may occur when working on the hydraulics:
uncontrolled discharge of the hydraulic fluid
accidental machine movements
flying away or bursting parts
skin diseases
Work on the hydraulics must therefore only be carried out by competent persons
with the appropriate specialist knowledge.
The machine is low-maintenance and only a few parts have to be serviced. Nevertheless,
malfunctions or defects which could impair the safety of the user must be rectified immediately!
Before each start-up, make sure that the machine is in perfect condition and functions
properly.
Once a week check all connections for tightness.
Regularly check whether the warning and safety labels on the machine are in perfect and
legible condition.
Only use perfect and appropriate tools.
Only use lubricants and original spare parts recommended by the manufacturer.
19.1.1
Inspection and maintenance plan
Type and degree of machine wear depend on the operating conditions. The following intervals
apply when using the machine within the specified limits:
Interval
Component
What to do?
Daily or
before every
start of work
Table
Check for damage
Hydraulic system Check for leakage
Breaks, castors
Check for correct functioning
Screws, bolts
Check for tight fit
Monthly
Moving parts
Oil/lubricate all moving parts monthly. Lubrication points: Cylinder
seat (oil); friction surfaces of the rollers (grease); hinge pins (oil);
pedal suspension point (oil); grease nipple (grease).
Annually
Hydraulic oil
Change the hydraulic oil (pump out used hydraulic fluid, fill in new
hydraulic fluid).
Hydraulic unit
Check hydraulic unit for leaks. A lifted load must not show any
discernible change in position after 10 minutes (max. 5 mm).
Hydraulic
cylinder
Bleed hydraulic cylinder.
Expert inspection If necessary, have an expert inspection carried out by an
authorised body.
As required
Hydraulic lines
Replace damaged hydraulic lines immediately.
