OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
27
TS 315SE
14
OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating the
device.
14.1
Operation instructions
W A R N I N G
Perform all machine settings with the machine being
disconnected from the power supply!
N O T I C E
Operating only with started dust collector!
Never start the machine when the workpiece is pressed to the saw
blade!
Before starting the machine check if the saw blade is tightened
Always adapt cutting speed to the respective working
Use the push stick to avoid the risk of contact with the saw blade
Slide the workpiece evenly, without relapses and without retake it
until the end of cutting.
14.2
Operation
Placement of the machine
For changing the place you have to use the wheels. By lifting the machine at the handles, the machine
is very easy moved. Regard that the floor is planar.
Starting/Stopping
Pushing the green switch
I
, the machine is turned on. It gets turned off by using the red switch
0
.
Adjustment of the blade depth
Always adjust the blade depth so, that the top of the saw blade
is about 2-3 cm over the work piece. It is adjusted by the hand
wheel
c
.
Adjustment of the blade tilt
For tilted cuts you have to open the lock screw
b
. Then you have
to open the second lock screw
a
. The tilt can now be adjusted
and read on the scale. Then the two lock screws have to be fixed
again.
Adjustment of the fence
Angular adjustment: At first you have to open the lock screw. The
angle can be read on the scale. For the most important angles
there are grooves. Using the detent these angles can be adjusted
easily. After the adjusting the lock screw must be fixed again.
Adjustment of the distance to the saw blade: Move the fence to the wished measure which can be
read on the scale.
