SAFETY
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
10
WB123A
10
SAFETY
10.1
Intended Use
The product must only be used for its intended purpose! Any other use is deemed to be a case of
misuse.
To use the product properly you must also observe and follow all safety regulations, the assembly
instructions lay down in this manual.
It is also imperative to observe the accident prevention regulations in force in your area.
The same applies for the general rules of occupational health and safety.
The product is used for:
As a workbench for woodworking or for storing tools, while the maximum permissible load must not
be exceeded.
N O T E
HOLZMANN MASCHINEN GmbH assumes no responsibility or warranty for other
activities and any resulting property damage or injuries!
Even when the product is used as prescribed it is still impossible to eliminate certain residual risk
factors.
Ambient conditions
The product may be operated:
Humidity
max. 70%
Temperature
+5°С to +40°С
Storage
-5°C to +55°C
The product shall not be operated outdoors or in wet or damp areas, only indoor use.
Inspect the product before starting work, if parts are damaged or loose, replace them immediately
or tighten them again.
General Safety Instructions
Make sure that all parts are firmly tightened together.
Ensure that the product is in stable and safe position
Prohibited use
The operation of the product outside the stated technical limits described in this manual is
forbidden
Any manipulation of the product and parts is forbidden
The use of the product for any purposes other than described in this user manual is forbidden
The product is not a children's toy
As a climbing aid or working platform
11
TRANSPORT
For proper transport, follow the instructions and information on the transport packaging
regarding centre of gravity, attachment points, weight, means of transport to be used and
prescribed transport position, etc.
Transport the product in its packaging to the place of installation. When lifting, carrying and
depositing the load, make sure that you are in the correct posture:
Lifting, Depositing
Ensure stability when lifting / setting down (legs hip width).
Lift / lower load with bent knees and straight back (like weightlifter).
Do not lift / lower the load jerkily.
Carrying
Carry load with both hands as close to body as possible.
Carry load with straight back.
Always secure the assembled
product
during transport in the transport position to prevent
damage to the
product
.
