Transport, packaging, storage
ADH-Series | Version 1.02
11
5
Transport, packaging, storage
5.1 Delivery and transport
Delivery
After delivery, check the planer-thicknesser for visible
transport damage. If you discover any damage to the
planer-thicknessers, report it immediately to the trans-
port company or dealer.
Carefully unpack the machine and all loose objects from
the wooden box and inspect them for damage. Read the
operating instructions thoroughly to familiarize yourself
with proper assembly.
Remove the screws securing the machine to the ship-
ping skip. Remove the protective layer from the table,
bed rollers, feed rollers, cutter head, and loose items
packed with the machine. The coating can be removed
with a soft cloth moistened with kerosene. Do not use
acetone, petrol or paint thinner for this purpose.
Do not use solvents to clean plastic parts.
Transport
Transport with a forklift/lift truck:
For shipping, the device packed in a carton is delivered
on a pallet so that it can be transported with a forklift
truck or pallet truck.
The forks of the forklift truck must be at least 1200 mm
long.
Transport by crane
Prepare 2 ropes or belts with the necessary load capa-
city and length.
The ropes are hung on the crane hook; the crane must
have the respective load capacity.
The ropes are then attached to the areas of the planing
and thicknessing machine reinforced for crane trans-
port, and the machine is then lifted by crane. Make sure
that the centre of gravity of the machine is taken into ac-
count.
Align the ropes well; if necessary, move the crane
slightly to ensure vertical and stable lifting;
Do not tilt the machine. Lifting the machine must be slow
and without jolting or swinging.
Put down the machine with the crane on the selected
place.
Unpacking
Step 1: Remove all parts from the carton. Do not throw
away the carton or packaging material until the
machine is set up and running satisfactorily.
Step 2: Inspect the contents for transport damage. Re-
port any damage to your dealer.
Tools required for assembly:
1x
Cross-point Screwdriver (approx. 2 ft)
1x Phillips-head
screwdriver
1x 4mm hex-wrench (included in delivery)
1x 5mm hex-wrench
1x 6mm hex-wrench (included in delivery)
1x 10mm box wrench
1x 13mm box wrenchr
5.2 Packaging
All packaging materials and packaging aids used in the
planer-thicknesser are recyclable and must always be
recycled.
Cardboard packaging components are crushed and
sent for waste paper collection.
The films are made of polyethylene (PE) and the pad-
ding parts of polystyrene (PS). You hand these materials
over to a recycling collection point or to the disposal
company responsible for you.
WARNING!
If the weight of the machine and the permissible load
capacity of the lifting equipment are not observed
during transport or lifting work, the machine may tilt
or fall.
- During transport and lifting work, observe the
weight of the unit and the permissible load capacity
of the lifting equipment.
- Check that hoists and load slings are in perfect
condition.
- Lifting and transport of the machine must be carried
out by qualified specialists. They must also have
the necessary special equipment at their disposal.
WARNING!
When lifting and transporting the machine, make
sure that there are no persons in the danger area
who could be injured by falling or tilting the machine!
NOTE!
During transport, the machine must be protected
from excessive vibration and moisture by appropri-
ate means.
NOTE!
The use of socket spanners and ratchets speeds up
the assembly time, but is not necessary.
Summary of Contents for 5904026
Page 57: ...Notes ADH Series Version 1 02 57 15 Notes ...
Page 58: ...www holzstar de ...
