14
DH-Series | Version 1.01
Operation
Fig. 15: Properly earthed socket outlet
Guidelines for extension cords
- Make sure that the extension cord is in good condi-
tion.
- When using an extension cord, be sure to use one
heavy enough to carry the current your product
will draw.
- An undersized cord will cause a drop in line
voltage, resulting in loss of power and cause over-
heating.
- Make sure that the extension cord is properly wired
and in good condition.
- Always replace a damaged extension cord or
have it repaired by a qualified person before using
it.
- Protect your extension cords from sharp objects,
excessive heat and damp or wet areas.
8
Operation
Erdungszinke
3 Zinken
Stecker
Ordnungsgemäß
geerdete Steckdose
Erdungszinke
3 Zinken
Stecker
WARNING!
Danger to life!
There is a danger to life for the operator and other
persons if they do not comply with the following
rules.
- The planer may only be operated by an instructed
and experienced person.
- The operator must not work when under the influ-
ence of alcohol, drugs or medication.
- The operator must not work if he is overtired or suf-
fers from illnesses affecting his concentration.
- The planer may only be operated by one person.
Other persons must stay away from the work area
during operation.
- Check the machine for damaged parts. If the pro-
tective equipment or guards are damaged, replace
them immediately.
- Test whether the moving parts can move freely for
the necessary function.
ATTENTION!
The following must be observed for safe operation:
- Do not lean too far forward when operating the pla-
ner.
- When operating the planer, always stand securely
with both legs on the ground and ensure that you
always keep your balance.
- Do not work with the machine if the ON/OFF switch
or the speed controller cannot be moved correctly.
WARNING!
The following must be observed for safe operation:
- Handle your tools with care: they can be very
sharp.
- When the machine is switched on, the workpiece
must not touch the tools.
- Let the machine run for a while after turning it on for
the first cut. During the running-in phase, be aware
of vibrations or drum noises that indicate improper
tool attachment.
NOTE!
The use of tools or devices other than those specified in
the operating instructions may pose a hazard to the
user.
