18
FKS 315-2000 E | Version 1.11
Care, Maintenance and Repair
Step 4: Spray all unpainted metal surfaces with some
anti-rust spray.
Step 5: Check the machine for damage to the safety de-
vices and saw blade. If necessary, carry out the
repair or arrange for it, observing the safety in-
structions.
Step 6: Check the machine regularly and replace if
necessary:
- Loose screws and nuts
- Worn or damaged switches
- Worn or damaged saw blade
- Worn or damaged blade guard
Step 7: Every 3 months, check the drive belts monthly if
used daily, replace if worn or damaged.
9.2 Maintenance and Repair
Maintenance and repair work may only be carried out by
qualified personnel.
If the panel saw does not work properly, contact a dealer
or our customer service. The contact details can be
found in chapter 1.2 Customer Service.
All protection and safety equipment must be reinstalled
immediately after completion of repair and maintenance
work.
9.2.1Blade change
Step 1: Disconnect the power plug from the socket.
Step 2: Set the saw blade inclination angle to 0 ° (90 ° to
the saw table) and move the saw blade up as far
as possible.
Step 3: Push the sliding carriage to the right as far as
possible, unscrew the two M6x12 screws and re-
move the saw blade guard.
Step 4: Remove the insert at the table.
Step 5: Insert the shaft pin into the hole on the inside of
the saw blade flange to lock the saw blade and
unscrew the saw blade nut clockwise with the
wrench.
Fig. 45: Unscrew the saw blade
Step 6: Remove the saw blade flange and saw blade.
Step 7: Place the new saw blade with flange and nut on
the shaft and tighten the nut (counterclockwise).
NOTE!
The bearings are closed and pre-lubricated. They are
maintenance-free for the normal life of the machine.
The bearing surfaces should always be kept clean to
ensure proper operation of the saw.
Wear safety gloves!
ATTENTION!
The saw blade measures 315 x 30 x 3 mm (outer dia-
meter, inner diameter, thickness)
ATTENTION!
Each time you change the blade thickness, you must
fit an appropriately dimensioned cutting blade and a
suitable auxiliary saw blade.
ATTENTION!
If the saw blade thickness has changed, an appropri-
ately dimensioned cutting knife and a suitable auxili-
ary saw blade must now be mounted.
