Operation
KGZ 305 E | Version 1.09 | EN
11
Fig. 12: Adjusting the laser
8.2 Cutting execution
The workpieces that can be machined are determined by
the specification of the saw blade.
Step 1: Switch on the laser to mark the cutting line
(Fig. 4).
Step 2: Position the workpiece at the workpiece stop and
hold it with one hand. If necessary, use the clam-
ping device to fix the workpiece.
Step 3: With the other hand grasp the saw head grab
handle and with the thumb pull the release lever
(3, Fig.13) for the saw button to the left.
Fig. 13: Turn the saw on / off
Step 4: Press and hold the ON/OFF switch (2, Fig.13).
Step 5: Lower the saw head onto the workpiece and
make the cut.
Step 6: When the cut is complete, release the on/off
switch (2, Fig.13) and lift the saw head up until
the saw head lock engages again.
ATTENTION!
Before the first start-up, check the function of the saw
and carry out a test run without workpiece.
WARNING!
Do not look in the laser beam!
WARNING!
- Danger of loss of finger limbs!
- Before switching on, check the functionality of the
safety devices, in particular the perfect condition of
the pendulum protective cover.
Risk of injury due to ejection of the workpiece and
jamming of the saw blade!
- Position the workpiece securely on the turntable
support and do not tilt the saw blade by lateral pres-
sure! Reduce the pressure of the saw head on the
workpiece if the rotational speed of the saw blade
decreases due to excessive load!
Risk of injury to the eyes due to flying chips or cut-
ting residues!
- Protect your eyes by using protective goggles.