8
EN: ESPRESSO MAKER |
Instruction Manual
” to the higher position, finally, clean the steam outlet with wet sponge, but care not to be burnt!
8.
Press and release the ON/OFF button “
” to cut off the power source.
9.
Pour the frothed milk into the espresso prepared, now the cappuccino is ready. Sweeten if desired, sprinkle the froth
with a little cocoa powder.
Note: Please follow the operation as below if the steam outlet is blocked: firstly turn the steam knob to “O” position and
make the coffee maker cool down for about half an hour, then poke the steam outlet for several times with a needle
about 1mm in diameter, finally, press down the coffee/steam button “
” and turn on the steam knob to check if
the appliance can produce steam normally when the steam indicator (yellow) illuminates. Please contact the service
department if the appliance can not produce steam after operate as above.
FROTHING MILK/PRODUCING STEAM TO HEAT LIQUIDS
The steam wand can be used to froth milk and make hot beverages like drinking chocolate, water or tea.
Method:
1.
Remove the removable tank and fill it with desired water, the water level should not exceed the “MAX” mark in the tank.
Then insert the tank into the appliance properly.
2.
Then connect the appliance to power supply.
3.
Press down the ON/OFF button “
” to turn on the unit, the power indicator (red) illuminates.
4.
Press down the pump control button “
” to the lower position, make sure the coffee/steam button “
” is at the
higher position, the pump will pump water, when there is water flowing out, close the pump immediately.
5.
Press down the coffee/steam button“
” to the lower position and wait for a moment, the appliance begins to heat
until the (yellow) lamp illuminates, it means the heating is finished.
6.
Dip the steam wand into the liquid to be heated. If you want to froth milk, dip the steam wand about 2 centimeters into
the milk. Turn the steam knob in anti-clockwise slowly to start making steam.
7.
Then the desired result is got, you can turn the steam knob to the “O” position.
8.
Please follow the operation as below to avoid the steam outlet being blocked after finish frothing milk each time: put an
empty jug under the steam band, then turn on the steam knob and press down the pump control button “
” to the
lower position, the pump will pump water, after the water flowing out for 30 seconds, press the pump control button “
” to the higher position, finally, clean the steam outlet with wet sponge, but care not to be burnt!
9.
Press and release the ON/OFF button “
” to cut off the power source.
Note: Please follow the operation as below if the steam outlet is blocked: firstly turn the steam knob to “O” position and
make the coffee maker cool down for about half an hour, then poke the steam outlet for several times with a needle
about 1mm in diameter, finally, press down the coffee/steam button “ ” and turn on the steam knob to check if
the appliance can produce steam normally when the steam indicator (yellow) illuminates. Please contact the service
department if the appliance can not produce steam after operate as above.
AUTOMATIC POWER OFF FUNCTION
The appliance will turn off automatically 25 minutes after pressing ON/OFF button.
CLEANING AND MAINTENANCE:
1.
Cut off power source and let the coffee maker cool down completely before cleaning.
2.
Clean housing of coffee maker with moisture-proof sponge often and clean water tank, drip tray and removable shelf
regularly then dry them.
Note: Do not clean with alcohol or solvent cleanser. Never immerse the housing in water for cleaning.
3.
Detach the metal funnel by turning it clockwise, get rid of coffee residue inside, then you can clean it with cleanser, but
at last you must rinse with clear water. Do not wash the metal funnel in a dishwasher.
4.
Clean all the attachments in the water and dry thoroughly.
Note: Clean the appliance after every use in order to make it work properly.
