12
(Pic.3) Put the nut (pos. A), the white plastic ring (pos. B)
and the sealing ring (pos. C) onto the DN 40 discharge pipe
as shown above and put the pipe into the inlet of the tank.
Connect the discharge pipe by tightening the nut to the inlet
device. The black sealing ring must be between the nut and
the inlet device.
Please do the same in case you want to install any addi-
tional sanitary units.
(Pic.4) To connect the pressure hose, please fasten the
DN 25 pipe at the outlet bow, which is on the right at the
tank of the Saniflux, with a clip.
Install the pressure hose upwards (best way: first vertically,
than horizontally) in a loop above the sewer level.
This will avoid that waste water will flow back into the tank
in case excess water (e.g. heavy rain) is in the sewer.
Install the pressure pipe directly to the next soil stack.
Please check again all connections and make sure that
they are sealed. Now connect the unit with the power cable
to the main supply and the unit is ready for operation.
Furthermore please pay attention to the hints below.
•
Install the unit in such a way, that the operation and
service elements are easily accessible. Make sure that
there is enough space (approx. 50 cm) between the
horizontal inlet and any wall.
•
To prevent a freezing of the discharge pipe please iso-
late the complete discharge pipe up to the sewer level.
8. Start-Up
In combination with the pneumatic level control the pump
starts and stops according to the liquid level in the tank.
9. Maintenance and Repair
Before maintenance or repair disconnect the pump
from the power supply to avoid accidental starting of the
pump!
Before maintenance or repair make sure that all rotat-
ing parts stand still!
In case of a defect of the unit, a repair shall be carried
out only by the manufacturer or through an authorized
workshop. Conversions or alternations of the machine/unit
are permitted only after arrangement with the manufacturer.
Only HOMA spare parts shall be used.
In accordance with the product liability law we point out
that we shall not be liable for damages caused by our
product due to unauthorized repair by persons other than
the manufacturer or an authorized workshop or due to the
use of spare parts other than original HOMA parts. The
same product liability limitations are valid for accessories.
Before carrying out maintenance and service, the pump
must be thoroughly flushed with clean water. Rinse the
pump parts in clean water after dismantling.
Pumps running under normal operation conditions should
be inspected at least once a year.
In accordance with DIN all connected sanitary appliances
must be installed in the same room as the pump.
Servicing Contract
For a regular expert execution of all necessary mainte-
nance and inspection we recommend the conclusion of a
servicing contract by our HOMA Service. Please contact
our HOMA customer service.
10. Fault Finding Chart
Before maintenance or repair disconnect the pump
from the power supply to avoid accidental starting of the
pump!
Fault Cause Remedy
Pump does not start
Supply failure
Check power supply
Impeller or cutting de-
vice is blocked by impu-
rities
Close the incoming
sewer, emptying the
tank with the dia-
phragm pump, open
the cover, clean the
tank with water and
remove solids which
may block the pump
Summary of Contents for Saniflux Series
Page 16: ...16 ...
