3. Foam Components
the foam parts are shown below. Each part has been
designed to fit into a specific location inside the cabinet.
Carefully remove the backing and place the foam using the
institutions below. Once the backing has been removed
and the foam is attached to the wall it can not be removed
without damage.
Bottom Floor Foam
Left
SIde
Foam
RIght
Side
Foam
Shelf 1
Shelf 2
J
Barrel Rest Mounting Bar
Foam for
Small Shelves
Shelf 4
Shelf 3
Shelf 5
Foam Installation
1. Measure the length of any guns that are going to be
stored in this cabinet. From this measurement, decide the
height that you will place the barrel rest to accommodate
your guns suitable. From this measurement cut the back
wall foam into two pieces at the height that you will place the
barrel rest. Any extra that is left may be placed above the
barrel rest on the back wall.
2. Apply the liner (D) to both sides of the cabinet. First
remove about 15” of paper at the bottom of (D) exposing
the adhesive. Press the foam liner into place – starting ½”
from the bottom of the cabinet. Continue to work upward
, slowly removing the paper and smoothing the foam into
place as you go. This will allow you to adhere the foam to the
