Control panel
Upward neck
Upper back
Lower back
Downward neck
How to use
1. Place the product on a chair (use the straps to keep it secure).
2. If using in the house, plug into a socket. If using in the car, connect
to the 12V DC car.
3. Press the ‘power’ button to start. The kneading back massage will
focus on the whole back, going up and down. The neck massage will
be on the upward mode. The air pressure function will be on medium
intensity, which is the default setting.
4. Use the controller to set the type of massage you require.
5. Press the ‘heating’ button – the lights on the massage head will turn
red, and the seat will heat up. Press again to turn the function off.
6. Press the ‘mode’ button to swich the vibration settings. There are
three modes – keep pressing to increase the intensity – press a fourth
time to exit this mode. The ‘intensity’ button can only be used if the
‘mode’ button is on.
7. Press the ‘air pressure’ button to switch its intensity. There are three
modes – the default is medium intensity. Note: You can turn off this
function – It will be off when the indicator on the side does not light up.
