7
STEP 7
Screw in 3 double sided bolts (25) into the top of the
damper (9) if not already assembled.
STEP 8
Take the damper assembly and connect to the top
of the upper supports (5). Connect with screws ( 17).
STEP 9
Fix the reflector (1 0) onto the damper {9) with the
wingnut (23), gasket (24) and bolt (25).
STEP 10
Next, carefully put the glass tube (8) up through the
center of the hole in the upper plate (6). Make sure
the rubber ring (22) is attached on the lower end of
the glass tube. Check and ensure the that the glass
tube covers the center hole of the middle plate. Fix
3 side panels (15) with screws (17). Make sure front
panel (16, with handle) is opposite of wheels.
STEP 11
Screw the handle(18) onto the front panel(16)
-attach the panel by inserting its two hooks into the
holes on the bottom plate(3). Hook the chain (19) to
the hole in the control box, then close the panel to the
middle plate-the panel is attached by the magnets
Tips: the chain can hold the panel while operating
the control
STEP 12
Lastly, attach the protection guards (1 1) onto the
upper frame by putting its hooks into the holes of the
frame. Secure the guards by fixing the holders ( 14)
with screws ( 17).
Summary of Contents for HCPHSSQ
Page 11: ...11 Notes ...
Page 12: ...Notes ...
