10
Maintenance
Storage
Service
WARNING
FOR YOUR SAFETY
DO NOT touch or move the heater for at least 45 minutes after use. The reflector is hot to the touch, allow the
reflector to cool before touching.
To enjoy years of outstanding performance from your heater, make sure you perform the following
maintenance activities on a regular basis:
Keep the exterior surfaces clean.
•
Use stainless steel cleaner for cleaning. Never use flammable or corrosive cleaning agents.
•
While cleaning your unit, be sure to keep the area around the burner and pilot assembly dry at all times. Do
not submerge the control valve assembly. If the gas control is submerged in water, DO NOT use it. It must be
replaced.
Air flow must be unobstructed. Keep controls, burner, and circulating air passageways clean. Signs of possible
blockage include:
•
Gas odor with extreme yellow tipping of flame.
• Heater does NOT reach the desired temperature.
•
Heater glow is excessively uneven.
• Heater makes popping noises.
•
Spiders and insects can nest in burner or orifices. This dangerous condition can damage heater
and render it unsafe for use. Clean burner holes by using a heavy-duty pipe cleaner. Compressed
air may help clear away smaller particles.
•
Carbon deposits may create a fire hazard. Clean dome and burner screen with warm soapy water if any
carbon deposits develop.
Note:
In a salt-air environment (such as near an ocean), corrosion occurs more quickly than normal. Frequently
check for corroded areas and repair them promptly.
Tip:
Use high-quality automobile wax to help maintain the appearance of your heater. Apply to exterior
surfaces from the pole down. Do not apply to emitter screen or domes.
BETWEEN USES
•
Turn Control Knob OFF.
•
Disconnect LP source and move to a secure, well-ventilated location outdoors.
•
Store heater upright in an area sheltered from direct contact with inclement weather (such as rain, sleet,
hail, snow, dust and debris).
•
If desired, cover heater to protect exterior surfaces and to help prevent build up in air passages.
• Never leave LP cylinder exposed to direct sunlight or excessive heat.
Note: Wait until heater is cool completely before transporting or covering.
Repair gas passages and associated components should be done only by a qualified service person.
Caution: Always allow the heater to cool before attempting service.
Summary of Contents for HCPHWKR
Page 11: ...11 Notes ...
Page 12: ...12 Notes ...
