Operation
User Servicing Instructions
Step 4. Allow branches to fall into place or gently pull branches up and
out. When adjusting branches be sure that all wires are free of
branch hinges. (See Fig. 7)
Step 5. Shape the branches. Starting with tips closest to the pole,
shape one tip to the right, one to the left and one at the center
of the main stem. Repeat pattern for each branch. (See Fig. 8)
Step 6. Plug the power cord from the tree section (C) into a proper
outlet. Please note this tree comes with a control box. Press
the button on the control box to select from the 4 lighting
functions listed below:
1. Warm white steady on 2. Multicolor steady on
3. Color changing 4.Off
Turning on the tree
Step 1. Plug the power cord from the tree section (C) into a proper
outlet.
Replace the fuse.
a)
Grasp plug and remove from the receptacle or other outlet device.
Do not unplug by pulling on cord.
b)
Open fuse cover. Slide open fuse access cover on top of
attachment plug towards blades.
c)
Remove fuse carefully.
d)
Risk of fire. Replace fuse only with 3 Amp,
125 Volt fuse (provided with product).
e)
Close fuse cover. Slide closed the fuse access cover on top of
attachment plug.
f)
Risk of fire. Do not replace attachment plug. Contains a safety
device (fuse) that should not be removed. Discard product if the
attachment plug is damaged.
Replace the lamp.
a)
Grasp plug and remove from the receptacle or other outlet device. Do
not unplug by pulling on cord.
b)
Unlock the burned out LED bulb by lifting the hook and pull lamp and
plastic base straight out of lampholder. Do not twist bulbs.
c)
Replace lamp with only 3.0 Volt, 0.06 Watt LED type lamp.(provided
with product)
d)
Lock the LED bulb.
If the new lamp base does not fit in lampholder, follow the steps
below before step c.
1.
Pull the reflector out.
2.
Remove the base of burned out lamp by straightening lamp
leads and gently pull lamp out.
3.
Thread leads of new lamp through holes in old base with one
lead in each hole(always match the long lead of new lamp to
the hook of lamp base)
4.
After lamp is fully inserted into base, bend each lead up, like other
lamps in the light set so that the leads will touch the contacts inside
the lampholder.
5.
Insert the reflector into the base.
CAUTION!–
ALWAYS UNPLUG YOUR TREE FROM
ITS POWER SOURCE BEFORE ATTEMPTING FUSE AND
B
ULB REPLACEMENT.
Step 1. Remove all ornaments and decorations.
Step 2. Unplug the cord from the wall outlet and then disconnect each
section of the tree. Remove the power cords from the tree
bottom (C).
Step 3. Gently lift the tree top straight up to remove from the center
section and fold all branches towards the pole.
Step 4. Repeat this step for the center and bottom tree sections.
Step 5. Carefully place all tree sections into a shipping box and tape it
shut.
Step 6. Store your tree in a cool, dry place away from sunlight.
Problem
Solution
The tree
does not
light
Ensure that connectors of all tree sections are
connected into each other well. Make surepower
cord plug is securely inserted into a working
electrical outlet.
Check for blown fuses at the power cord plug. Replace
as needed with the replacement fuses provided.
Check for loose, broken, or missing bulbs and replace
as needed with the replacement bulbs provided.
If you are still experiencing problems with the tree
please call 1-877-527-0313 for instructions.
Model No. LTW605-C5-1
Care and Cleaning
Troubleshooting
