Safety Information
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical products, basic precautions should always be
followed including the following:
a)
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS.
b) This product is for indoor use only. The electrical rating 0.45 A 120 V 60
Hz.
c) Do not use seasonal products outdoors unless marked suitable for
indoor and outdoor use. When products are used in outdoor applications,
connect the product to a Ground Fault Circuit Interrupting (GFCI) outlet. If
one is not provided, contact a qualified electrician for proper installation.
d) This seasonal use product is not intended for permanent installation or
use.
e) Do not mount or place near gas or electric heaters, fireplace, candles or
other similar sources of heat.
f) Do not secure the wiring of the product with staples or nails, or place on
sharp hooks or nails.
g) Do not let lamps rest on the supply cord or on any wire.
h) Unplug the product when leaving the house, when retiring for the night,
or if left unattended.
i) This is an electric product – not a toy! To avoid risk of fire, burns personal
injury and electric shock it should not be played with or placed where small
children can reach it.
j) Do not use this product for other than its intended use.
k) Do not hang ornaments or other objects from cord, wire, or light string.
l) Do not close doors or windows on the product or extension cords as this
may damage the wire insulation.
m) Do not cover the product with cloth, paper or any material not part of the
product when in use.
n) Read and follow all instructions that are on the product or provided with
the product.
o)
SAVE THESE INSTRUCTIONS.
CAUTION! –
ALWAYS UNPLUG YOUR TREE
FROM ITS POWER SOURCE BEFORE ASSEMBLING OR
DISASSEMBLING.
CAUTION
1.
Risk of fire. This product does not contain lamp shunts, which allow
the product to operate if one lamp burns out.
2.
The product consists of non-replaceable LED lamps. To reduce the
risk of fire or electric shock, do not attempt to replace lamps or modify
string.
12 ft Braxton LED Pre-Lit Tree
SKU# 1001344019
Package Contents
A.
Top Section
Qty: 1
B.
Upper
Middle
Section
Qty: 1
C.
Middle Section
Qty: 1
D.
Lower Middle
Section
Qty: 1
E.
Tree Bottom
Qty: 1
F.
Tree Stand
Qty: 1
G.
Eye bolt
Qty: 3
H.
Power Cord
with a foot
pedal switch
Qty: 1
I.
Remote control
Qty: 1
Assembly
Assembling the tree stand
Step 1. Choose a location near a wall outlet.
Step 2. Open the stand to a 90 degree angle until the hole lines up with the
hole on the tube.
Step 3. Screw three eye bolts into the corresponding holes.
Pre-Assembly
