Christmas Tree
Model: TV90CH520S00
Sku # 1003 173 282
Care and Cleaning
Step 1. Remove all ornaments and decorations.
Step 2. Unplug the cord from the wall and then unplug each section
of the tree.
Step 3. Gently lift the tree top straight up to remove from the center
section and fold all branches towards the pole.
Step 4. Repeat this step for the center and bottom tree sections.
Step 5. Carefully place all tree sections into a shipping box and tape it shut.
Step 6. Store your tree in a cool, dry place away from sunlight.
User servicing instructions
Fused Lamp Replacement
WARNING -
Risk of fire: This product employs overload protection (fuse
lamp) in each series light circuit to provide overload protection in addition
to the fuse(s) located in the plug. Do not replace the fuse lamp contained
in this set with any other type of lamp, use only spare fuse lamps provided
with this product. In case of a burnt out FUSED lamp, the entire series of 50
lamps will be out. To replace the fused lamp:
1. Grasp the plug and remove from the receptacle or other outlet device.
Do not unplug by pulling the cord.
2. Locate the fused lamp with gray color lamp holder. Pull the burnt fused
lamp and plastic lamp base straight out of the lamp holder.
3. Replace with a spare fused lamp. The fused lamp can be distinguished
by a gray lamp base and an additional clear plastic cover.
4. Plug in the lights again.
Fuse replacement
1. Grasp plug and remove from the receptacle or other outlet device. Do
not unplug by pulling on cord.
2. Open fuse cover. Slide open fuse access cover on top of attachment
plug towards blades. 3. Remove fuse carefully.
4. Risk of fire. Replace fuse only with 7 Amp, 125 Volt fuse for the power
cord set.
5. Close fuse cover. Slide closed the fuse access cover on top of
attachment plug.
6. Risk of fire.Do not replace attachment plug. Contains a safety device
(fuse) that should not be removed. Discard product if the attachment
plug is damaged.
SPARE FUSE
The tree
does not
light
Troubleshooting
Problem
Solution
Ensure that all tree sections are plugged into
each other and that the tree is plugged into the
wall. If your tree came with a foot pedal, step on
the On/Off button.
Check for loose, broken, or missing bulbs and
replace as needed with the replacement bulbs
provided.
Check for blown fuses at the light string and
power cord plugs. Replace as needed with the
replacement fuses provided.
For blown fuses (if applicable), please refer to
User Servicing Instructions – Fuse Replacement
and replace as instructed.
TM
