Assembly
Assembling the Spiral Tree
For Indoor Use:
(1) Place the Tree Stand (F) flat on the floor. Fig.1
(2) The Tree Stand has a short vertical stub projecting upwards from it. Insert one Pole Section(E),
with big the end down, into the vertical stub. Attached the Plastic Cap (D)to the top of the Pole
Section . Fig.1
(3) Hold the Spiral Tree (B)at the top of the Pole section. Insert the Pole Section into the disc at the
top of the Spiral Tree. Let the Spiral Tree uncoil over the Pole Section (E).Fig.2
(4) Place the Star Tree Topper(A) into the holder at the top of the Spiral Tree. Fig.2
(5) Attach the hooks at the end of the two supporting strings at the base of the Spiral Tree into the
metal holes on the stand. Fig.2
For Outdoor Use:
(1) One of the arms of the Tree Stand is tapered. Drive the sharp arm of the Tree Stand into the
ground using the Driving (C) on the opposite end of the Tree Stand, as shown in. Fig. 3
(2) Repeat Steps 2-5 from Indoor Use above. (Note: Be sure to remove Driving Cap)
Pre-Operation
CAUTION:
Grasp the plug to insert or remove from the power source. Do
not unplug by pulling on cord.
CAUTION:
The lighting string on this product is rated at 57.6 Watts
(0.48Amps). Do not overload. Do not connect to other lighting strings, decorative outfit or
other electrical products. Before you use or re-use this product inspect it carefully. Return
to Store or discard if the product has cuts, damage or frayed wire insulation on
cords, cracks in the socket enclosures, loose connections or exposed copper wire.
Care and Cleaning
a. Carefully remove the product from wherever it is placed. This helps to avoid any undue
strain or stress on the product, wire and lighting connections. If the product is placed
somewhere other than the ground it should be well secured and stable.
b. Wipe the unit with a damp cloth and allow the unit to dry before storing.
c. Store the product neatly in a cool, dry location protected from sunlight.
FOR INDOOR AND OUTDOOR USE
Fig. 1
Fig. 2
Fig.3
