Assembly
Assembling the Tree
Step 1. Align the inner piece and outer piece of Tree Stand (J) to fit together. Insert the short Pole
(H) into the center tube of Tree Stand. Fasten them with the pre-attached Screws (G). Fig.1
Step 2. Place the Lower half of the Tree pole (C) into the upper end of short pole in Tree Stand and
tighten them together with the Wing Nut/Bolt (I). Fig.1
Step 3. Place the Upper half of the Tree (B) onto the Lower half and tighten them together with the
Wing Nut/Bolt (I).
Step 4. Place the Tree Top into the Top of the Tree (A). Fig.1
Step 5. The branches are pre-bundled. Gently pull the branches apart. Make sure the inner end of
each main branch is properly secured in the hook on the pole.
Step 6. Gently pull the mini branches apart to form a fully extended tree shape. Fig.1
Assembling the Tree and Securing to Ground
Step 1. Place the Driving Cap (F) on the top of the Long sharp end Pole Ground Stake (K) and drive
into the ground. Remove the cap. Fig.2
Step 2. Repeat Step for indoor use step 1.Then put the tree stand onto the Long Pole stake. Repeat
Step for indoor use step 2-6. Fig.3
Step 3. Each anchoring string provided has a "S" Hook (E) at one end. Tie up the free end to the
ground stake. Evenly attach each "S" hook of four strings to the root of each cluster of branches
approx. 3/4 length up the Tree as shown in Fig.3.
Step 4. Pull the String tight and drive the Ground Stake (D) at the other end into the ground to
secure the Tree. Fig.3
Pre-Operation
CAUTION:
Grasp the plug to insert or remove from the power source.
Do not unplug by pulling on cord.
CAUTION:
The lighting string on this product is rated at 33.6 Watts
(0.28Amps). Do not overload. Do not connect to other lighting strings, decorative
outfit or other electrical products. Before you use or re-use this product inspect it
carefully. Return to Store or discard if the product has cuts, damage or frayed wire
insulation on cords, cracks in the socket enclosures, loose connections or exposed
copper wire.
Care and Cleaning
a. Carefully remove the product from wherever it is placed. This helps to avoid any
undue strain or stress on the product, wire and lighting connections. If the product
is placed somewhere other than the ground it should be well secured and stable.
b. Wipe the unit with a damp cloth and allow the unit to dry before storing.
c. Store the product neatly in a cool, dry location protected from sunlight.
FOR INDOOR AND OUTDOOR USE
