10
Assembly — Close-to-Ceiling Mounting
1
2
3
Assembling the fan
Preparing the motor
Preparing the canopy
□
Remove the canopy ring (B) from the canopy (C).
□
Remove the two non-slotted canopy mounting screws
with lock washera (BB) from the canopy (C), and
loosen the slotted canopy mounting screwa with lock
washera (BB) on the canopy (C).
□
Remove the canopy bottom cover (D) from the canopy
(C)
.
□
Route the wires exiting from the top of the fan motor
assembly (G) through the canopy ring (B).
□
Make sure the slot openings of the canopy ring (B)
are on top, and then proceed to place the canopy ring
(B) and canopy (C) over the collar at the top of the fan
motor assembly (G).
□
Align the mounting holes on the bottom of the
canopy (C) with the holes on the top of the fan motor
assembly (G), and fasten using the three collar
mounting screws with lock washers (II) previously
removed.
□
Tighten the collar mounting screws (II) securely.
WARNING:
Failure to completely tighten the three collar
mounting screws (II) could result in the fan becoming loose
and possibly falling.
G
II
C
B
G
II
□
Remove the cotter pin (EE) and clevis pin (DD), and
two collar setscrews (HH) from the motor collar.
□
Remove three of the six collar mounting screws with
lock washers (II) (every other one) from the collar on
top of the fan motor assembly (G).
DD
EE
HH HH
D
BB
BB
C
B
A
