7
Making the electrical connections
Assembly — Hanging the Fan (continued)
WARNING:
Check to see that all connections are tight,
including ground, and that no bare wire is visible at the wire
nuts, except for the ground wire.
NOTE:
The fan must be installed at a maximum distance of
20 ft. from the remote control for proper signal transmission
between the remote control and the fan's receiving unit.
13
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
CAUTION:
To reduce the risk of electric shock, this fan
must be installed with an isolating wall control/switch.
AA
White
White
Black
KK
Green
Black
Black
Ground
conductor
White
White
Black
LL
A
E
Green
If you feel you do not have enough electrical wiring knowledge
or experience, have your fan installed by a licensed electrician.
Follow the steps below to connect the fan to your household
wiring. Use the plastic wire nuts (AA or KK) with your fan.
Secure the plastic wire nuts (AA or KK) with electrical tape.
Make sure there are no loose strands or connections.
□
Make wire connections from the fan to the receiver (K)
and outlet box (LL) as follows, using the wire nuts (KK).
From Fan To Receiver
Black Wire -------------------- Black Wire "To Motor L"
White Wire -------------------- White Wire "To Motor N"
□
Make wire connections from the receiver (K) and fan to
the outlet box (LL) as follows, using the wire nuts (AA).
From Receiver To Outlet Box
Black Wire "AC in L" ---------- Black Wire (Hot)
White Wire "AC in N" --------- White Wire (Neutral)
From Fan To Outlet Box
Green Wires* ----------------- Green or Bare Wire (Ground)
* There are two green grounding leads: one from the mounting
bracket (A) and one from the hanger ball/downrod assembly (E)
if installed.
□
Turn the wire nut connections upward, spreading them
apart so the green (ground) and white wires will be on
one side of the outlet box (LL) and the black and blue
wires will be on the other side. Carefully tuck the
connections up into the outlet box (LL).
K