Home Decorators Collection 1003 939 583, Use And Care Manual

11

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.

Assembly - Attaching the Light Kit

Attaching the light kit fitter assembly

2

☐

Remove one screw (QQ) from the light kit pan (G) and loosen, 
but do not remove the other two screws.

☐

Connect the wires from the light kit fitter assembly (H) to 
the wires from the fan motor assembly (E) by connecting the 
molded adaptor plugs together. Carefully tuck all wires and 
splices into the switch cup.

☐

Push the light kit fitter assembly (H) up to the light kit pan 
(G) so that the two loosened screw heads fit into the keyhole 
slots. Turn the light kit fitter assembly (H) clockwise to secure.

☐

Re-install the screw (QQ) that was removed in step 1.

☐

Make sure all the screws are firmly tightened.

CAUTION:

  To reduce the risk of electric shock, disconnect 

the electrical supply circuit to the fan before installing the 

light kit pan.

Installing the shatter resistant bowl

3        

☐

Place the shatter resistant bowl (I) into the light kit pan (G), 
aligning the three flat areas on the top flange of the shatter 
resistant bowl (I) with the three raised dimples in the light 
kit pan. 

☐

Turn the shatter resistant bowl (I) clockwise until it stops.

☐

Attach the pull chain extensions (CC) provided to the fan and 
light pull chain.

CAUTION:

  Make sure the power is off before attaching or 

removing the shatter resistant bowl.

WARNING:

 Allow the shatter resistant bowl to cool completely 

before removing.

1

Installing the light kit pan

☐

Remove one screw (PP) from the black bracket below the fan 
motor assembly (E), and loosen but do not remove the other two 
screws.

☐

Connect the wires from the light kit pan (G) to the wires from 
the fan motor assembly (E) by connecting the 9-pin connectors 
together. Carefully tuck all wires and splices into the switch cup.

☐

Push the light kit pan (G) up to the fan motor assembly (E) so 
that the two loosened screw heads fit into the keyhole slots. 
Turn the light kit pan (G) clockwise.

☐

Re-install the screw (PP) that was removed in step 1.

☐

Make sure all the screws are firmly tightened.

IMPORTANT:

 It is critical to attach the light kit pan using the 

quick connector. The fan will not operate unless the light kit 

pan is connected to the fan.

G

E

PP

I

G

CC

H

G

QQ