8
Attaching the fan to the electrical
box
□
Loosen the two mounting screws (GG) in the outlet box.
□
Pass the 120-Volt supply wires through the center hole in the
mounting bracket (A).
□
Slide the mounting bracket (A) on to the mounting screws (GG)
and center the mounting bracket (A) in relation to the outlet box.
If necessary, use leveling washers (not included) between the
slide-on mounting bracket (A) and the outlet box. The flat side of
the slide-on mounting bracket (A) should face toward the outlet
box, as shown.
□
Securely tighten the two mounting screws (GG).
1
WARNING:
To reduce the risk of fire, electric shock
or personal injury, mount to outlet box marked
“Acceptable for fan support of 35 lbs 15.9 kg) or less”,
and use screws provided with the outlet box.
NOTE:
The mounting bracket (A) is designed to slide
into place on an outlet box with the outlet box screws
(GG) installed.
Assembly - Standard Ceiling Mount (continued)
Assembling the fan
□
Loosen, but do not remove, the setscrew (KK) on the collar (PP)
on top of the fan-motor assembly (E).
□
Install the downrod (B) by inserting it into the motor collar (PP),
and turning it clockwise until the holes at the bottom of the ball/
downrod assembly (B) align with the holes in the collar on top of
the fan-motor assembly (E).
□
Carefully insert the hanger pin (CC) through the holes in the collar
and ball/downrod assembly (B). Be careful not to jam the hanger
pin (CC) against the wiring inside the ball/downrod assembly (B).
□
Insert the locking pin (DD) through the hole near the end of the
hanger pin (CC) until it snaps into its locked position.
□
Re-tighten the setscrew (KK) on the collar (PP) on top of the fan-
motor assembly (E).
WARNING:
Failure to properly install the locking
pin (DD) could result in the fan becoming loose and
possibly falling.
CAUTION:
To ensure wobble-free operation and to avoid
damage to the fan, the downrod (B) and the setscrew (KK)
must be completely tightened.
4
E
CC
C
D
DD
PP
JJ
KK
B
Assembly - Hanging the Fan
A
GG
GG
