Assembly — Installing the Light Kit
12
□
Remove one of the three switch housing mounting screws
(UU) from the mounting ring (VV) and loosen the other two
screws (UU). (Do not remove.)
□
While holding the switch housing (I) under the fan motor
assembly (F), snap together the wire connection plugs
(WW).
□
Place the key holes in the switch housing (I) over the two
screws (UU) previously loosened from the mounting ring
(VV). Turn the switch housing (I) until the switch housing
(I) locks in place at the narrow section of the key holes.
□
Securely tighten the two switch housing mounting screws
(UU) previously loosened and the one previously removed.
CAUTION:
Before starting installation, disconnect the
power by turning off the circuit breaker or removing the fuse
at the fuse box. Turning power off using the fan switch is not
sufficient to prevent electric shock.
Attaching the light kit to the
switch housing
□
Remove one of the three light kit mounting screws (XX)
from the switch housing (I) and loosen the other two
screws (XX). (Do not remove.)
□
While holding the 20W LED light kit (J) under your fan
motor assembly (F), make the polarized plug connections
(YY):
- White to white
- Black to blue
□
Carefully push all wires back into the switch housing (I).
Place the key holes in the 20W LED light kit (J) over the
two mounting screws (XX) previously loosened from the
switch housing (I). Turn the 20W LED light kit (J) until the
20W LED light kit (J) locks in place at the narrow section
of the key holes. Secure by tightening the two light kit
mounting screws (XX) previously loosened and the one
previously removed.
11
Attaching the switch housing
to the mounting ring
YY
F
XX
J
I
F
I
UU
VV
WW
15
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.